Payment & Shipping Terms:
|Connection Type:||Weld||Standard:||ASME BPE / 3A|
ss sanitary fittings,
stainless steel sanitary pipe fittings
ASME BPE TP316L Stainless Steel Sanitary Clamp Welded Sanitary Fittings
Sanitary fittings include sanitary elbows, sanitary tees, sanitary cross, sanitary clamps, sanitary ferrules, sanitary adapters, sanitary reducers, sanitary flanges, sanitary end caps and sanitary pipe holders.
Sanitary clamp fittings are with sanitary clamp ends. They are widely used in pipeline systems for food, dairy, beverage, cosmetic, pharmaceutical, and fine chemical industries.
Spezilla's stainless steel asme bpe sanitary fittings are applicable to a wide range of manufacturing industries:
2. Beverage processing
4. Pharmaceutical Production
5. Personal Care
1. Material Controlled & Machined Precisely.
2. Easily welded
3. Quickly fit up
4. High corrosion resistant
5. Long service life
6. Safety Stock System.
7. Well packaged
8. Fast delivered
9. Surface Finish: #180 Grit, #320 Grit
|SS316--Heavy Duty Single Pin Clamp|
70° F *
Material and Traceability
All fittings are permanently marked with original heat numbers for full traceability back to the original material supplier. MTR information is provided with each fitting. All tubular materials meet ASTM A269/ A270 requirements and all machined components meet the requirements of ASTM A479. Fully documented ASME-BPE conformance certification is available upon request.
Spezilla fittings are solution annealed and quenched in a vacuum furnace. This treatment relieves stresses caused by cold forming operations used in the manufacturing process, thereby removing the potential for stress corrosion and improving the dimensional stability of fittings.
I.D. finishes will be available in 10RA through 32RA. I.D. finishes may be provided in mechanical polish,
or with Electropolishing per ASME BPE specifications. Optional finishes and treatment available upon request. O.D. finishes will be 32RA unless otherwise specified.
Each fitting is marked with the following:
• Heat Number
• Material Alloy
• ASME BPE
• Surface Designation per ASME BPE
Fittings are visually inspected for surface finish imperfections as mentioned in table SF-3 in the ASME BPE 2005 specification. Additional percentages of every manufactured batch undergo a thorough dimensional evaluation with a 0% tolerance for failure. As a part of rigorous inspection standard, heat number traceability is verified for accuracy and chemical composition, per table DT-3, before the fittings are packaged for shipment.
• Wall Thickness
• Squareness of Face
• Off Angle
• Off Plane
The ends are capped to prevent damage and contamination. All fittings are packaged in bags. All bags are labeled with Spezilla Part Number, Heat Number(s), ASME-BPE, and the appropriate ASMEBPE Surface Finish Designation for reorder, traceability and tracking purposes.
|C / Max.||0.035|
|Mn / Max||2.00|
|P / Max||0.045|
|S / Max||0.005 - 0.017|
|Si / Max||1.00|
|Ni||10.00 - 14.00|
|Cr||16.00 - 18.00|